IBM 4002-C2A, Installation And User Manual

Page: 70 / 98

To remove a SFP or XFP transceiver from a gigabit Ethernet or 10-gigabit Ethernet
port, do the following:
1.
Put on the ESD wrist strap and ground yourself by attaching the clip end to a
metal surface (such as an equipment rack).
2. Disconnect the cable connector from the transceiver.
3. Insert the protective covering into the port connectors.
4. Pull the transceiver out of the port by pulling the bail latch forward, away from
the front panel of the module. This unlocks the transceiver from the front
panel.
Note: The bail latch may be attached to either the top or the bottom of the
transceiver.
5. Grasping the bail latch, pull the transceiver out of the port.
6. Store the fiber optic module in a safe, static-free place or in an anti-static bag.
7.
Install a new fiber optic module in the port. For information about performing
this task, see “Installing a new SFP or XFP transceiver.”
Installing a new SFP or XFP transceiver
You must install a SFP or XFP transceiver in each gigabit Ethernet and 10-gigabit
Ethernet fiber port you want to use.
You can install a new transceiver in a port while the device is powered on and
running.
Before installing one of these modules into the port, obtain an ESD wrist strap
with a plug for connection to a metal surface.
CAUTION:
For safety reasons, the ESD wrist strap should contain a series 1 meg ohm
resistor.
To install a SFP or XFP transceiver, do the following:
1. Put on the ESD wrist strap and ground yourself by attaching the clip end to a
metal surface (such as an equipment rack) to act as ground.
2. Remove the new transceiver from its protective packaging.
3. Gently insert the transceiver into the port until the module clicks into place.
The transceiver is keyed to prevent incorrect insertion.
net_com001
bail latch
net_com002
44
IBM Ethernet Switch c-series Installation and User Guide