Removing and Replacing the Power Supply
DANGER
Do not attempt to open the covers of the power supply. Power supplies are
not serviceable and are to be replaced as a unit. (RSFTD217)
To remove the power supply from the 7206 Tape Drive:
1.
Perform the cover removal procedure. Refer to “Removing and Replacing the
Cover” on page 28.
2.
Tilt the 7206 Tape Drive on its side. Support the power supply (
1
in
Figure 12) while removing the power supply mounting screw
2
from the
bottom.
3.
Support the power supply while returning the 7206 Tape Drive to its original
position.
4.
Disconnect the power supply connector (J1) (
3
from the drive.
5.
Disconnect the power supply connector (J2)
4
between the power supply and
the cooling fan.
6.
Grasp the rear of the power supply and while pressing it toward the front
panel, lift the rear of the power supply from the chassis.
7.
Push the power switch push button
5
out of the front panel and set it aside.
Figure 12. Removing and Replacing the Power Supply
32
7206 Model 220 Service Guide
Summary of Contents for 220
