©Copyright LOTRONIC - 2013
4
V. Operation
-
Place the fog machine on the ground, remove the cap of oil tank, fill in the high quality smoke oil, then
seal tight the cap.
-
Insert the power plug into the rear socket of fog machine,
and turn the red switch which on the rear panel be ON
(POWER ON/OFF), and low fog machine will be working.
-
When the green LED indicator which on the rear of fog
machine is ON, it means the fog machine has finished
warm up and is ready for working. Press the button of
remote controller to output smoke. When the green LED
indicator is “OFF”, it means the fog machine is in warming
up status.
VI. Appendix
The smoke outputting of low fog machine is via ice and from the outlet, this will increase the weight of
smoke, and keep it rising slowly from the ground, create a special effect.
1. All fog machines with condensing function, it will condense water vapor or humidity, so, it should be
considered before installing the fog machine
2. All fog machines will occasionally have a little amount of smoke spray out during operation or after
operation, It will back to output status when the warming up is ready.
3. Please do not spay at the people
4. Please don’t use the fog machine when fog oil is used up in order to avoid pump overheat and damage
the machine.
5. It’s normal that the fog machine will make little noise in working status.
VII. Maintenance
Cleaning and Using Frequency of Product
Please clean your low fog machine regularly, this can help to reduce the replacement of parts and
charges by maintenance.
The fog liquid should be clear and not polluted, the cap should be drive tight after filled the fog liquid.
When the fog machine worked 40 hours continuously, please use 80% of the distilled water and 20% of
the white vinegar to clean the impurity which inside the tube of heater.
Remove the nozzle before the fog machine is warming up, use the vinegar to clean it and keep clean
Pour out the fog liquid, and clean it same as described above, meanwhile switch ON the power and
warming up.
Use the fog machine at open place until the fog liquid has used up
Other Notices:
● All fog machines may be jammed because of the fog liquid filtering dirt or heat. Therefore, the
periodically maintenance will keep it in good state.
●
Please use the dry cloth for cleaning; please keep clean when storing it.
VIII. Trouble-shooting
Problem
Solution
The equipment don’t spray
1. Check if the fog liquid is used up
2. Check if the nozzle is jammed
3. Check if the pump works
4. Check if the thermocouple or thermostat is damaged
Reduced smoke output
1. Check if the nozzle is jammed by impurities
2. Check if the intensity of pump gets weak
Particular smell
Unplug the unit immediately from the mains and check if the
heating element is melted
Remote control
