ibico Patriot 25E, Operator'S Manual

Page: 16 / 46

© 2002 IBICO Page 5-2
Patriot 25 E Operations Manual
(8) PULL ROLLERS: The pull rollers, located at the
back of the laminator, are motor driven. They
simultaneously pull the film and improve the quality of the
laminated item.
(9) REAR SLITTER: Used to cut the film web where it
exits the rear of the laminator. To make a cut, press and
hold down the blade lever and slide across the rear of the
laminator.
WARNING: Never reach over the laminator to
operate the film cutter. Reaching over can make you
unstable and may cause serious bodily injury.
CAUTION: Exercise extreme caution when working
around or replacing the film cutter blade. This blade
is sharp and can cut you.
(10) CIRCUIT BREAKER: Electrical safety device,
located under the drive side cabinet cover, can be reset
by the operator if tripped.
CAUTION: If the circuit breaker trips a second time
after being reset, contact your service representative
for assistance.
(11) CORE ADAPTERS: The film shaft holds the supply
roll while the core adapters hold the rolls of film on the
shaft.
Core adapters
Thumb screws
(12) FILM WEB: Laminating film loaded into the machine
Film web
(13) NIP POINT: The point at which the top and bottom
rollers come into contact. The nip point of the heat rollers
is the place at which the items for lamination are introduced
into the laminator.
CAUTION: Only feed acceptable materials through
the nip of the rollers. Unacceptable materials may
cause damage to the rollers.
Nip point