ibico Patriot 25E, Operator'S Manual

Page: 23 / 46

© 2002 IBICO Page 6-3
Operations Manual Patriot 25E
6.2 Starting an application
CAUTION: Ensure the safety shield is in the fully
closed position and the feed table is properly installed
with the table interlock latch in position.
1.
Turn the laminator on by pushing ON/OFF to the “I”
position.
2.
The laminator will automatically default to the 1.5 & 3
MIL setting.
3.
The laminator will set the speed and temperature for
the respective film and 20 lb. bond paper (copier paper).
INFORMATION: Decrease speed by pressing
SLOW if laminating heavier stock. Increase speed
by pressing FAST if you are laminating lighter stock.
Refer to Section 4.6 Speed guide and helpful hints
INFORMATION: HEAT may illuminate if
increasing speed to high. If the adhesive is not
activating (becomes tacky), slow the speed down to
achieve quality lamination.
4.
Adjust the feed guide while you wait for READY to
illuminate. Do not run any material through the laminator
until READY has illuminated.
5.
Position the item(s) on the feed table to be laminated.
6.
Ensure the rear slitter is completely to one side on the
laminator.
CAUTION: Anything obstructing the path of the film
exiting the rear of the laminator may cause a film
jam (wrap-up).
7.
Press RUN. The rollers will begin to turn.
8.
Wait for the heat line (dwell line) to disappear, then
push the items into the nip point of the heat rollers.
Additional items can be laminated without stopping and
starting the laminator.
9.
Once the last item laminated has completely exited the
rear of the laminator, press the STOP.
10.
Use the rear slitter to trim the laminated items from
the web.
WARNING: Never reach over the laminator to
operate the film cutter. Reaching over can make you
unstable and may cause serious bodily injury.
11.
Turn the laminator off by pushing the On/Off switch
to the “O” position.
INFORMATION: You do not need to un-web the
laminator after turning power off except to clean the
rollers. Refer to Section 7.2 Clean the rollers.