13
Inspecting the supply cord
; Do not pull or carry the tool by the
electric cord or allow its contact with edges, sharp, rough
surfaces that may damage its flexible and insulating properties.
Keep the air vents of the gun clean at all times
. If possible,
prevent foreign matter from entering the vents.
The use of any accessory not recommended for use with this tool
could be hazardous. Always unplug the tool before attaching or
removing accessories. Do not remove accessory tips until the tool
has cooled to room temperature.
Suspected malfunctions are often due to causes that the users can
fix themselves, therefore check the product using this section.
Problem
Possible Cause
Solution
1. Gun will
not start.
1.1
Not plugged in.
1.2 Blown circuit fuse.
1.3 Circuit breaker is
tripped.
1.4 Cord or switch is
damaged.
1.1 Plug tool into a
working outlet.
1.2 Replace circuit fuse.
1.3
Reset circuit breaker.
(If the gun repeatedly causes
the circuit fuse to blow or
breaker to trip, discontinue
use immediately and have it
serviced at our service
centre or authorized
servicer)
1.4
Have the cord or
switch checked by a
qualified technician, if
required replace it.
TROUBLESHOOTING
IBL HG20-82
Summary of Contents for HG20-82
Page 1: ...HEAT GUN HG20 82 ...
Page 2: ...1 ...
