62
Note:
It is recommended that you use an Ethernet connection to configure it
4.
Troubleshooting
This Chapter provides solutions to problems for the installation and operation of the WiFi
Broadband Router. You can refer to the following if you are having problems.
1
Why can’t I configure the router even the cable is
plugged and the LED is lit?
Check
Ping test
to make sure that the iB-WRC300N Router is responding.
Go to
Start > Run
.
1.
Type
cmd
.
2.
Press
OK.
3.
Type
ipconfig
to get the IP of default gateway.
4.
Type “
ping 192.168.1.1
”.
Assure that you ping the correct IP Address assigned
to the 300M MIMO ADSL2+ Broadband Router. It will show four replies as below.
Ensure that your Ethernet Adapter is working, and that all network drivers are installed
properly. Network adapter names will vary depending on your specific adapter. The
installation steps listed below are applicable for all network adapters.
Summary of Contents for iB-WRC300N
Page 1: ...1 300M MIMO ADSL2 Broadband Router Model No iB WRC300N User Manual Ver 1 0 0...
Page 11: ...11 Step 2 Select Language then click Next to continue Step 3 Then click the Wizard to continue...
Page 12: ...12 Step 4 Click Next to continue Step 5 Select Wireless Enable and then click Next to continue...
Page 22: ...22 3 1 Basic Network Status Info Note You can see all the status of this Router on Status page...
