
ibaW-750
Manual
Issue 1.1
27
Since the configuration was locked by the other ibaPDA computer, it can neither be
changed nor applied.
A locked device configuration can only be changed or reset by the original owner or
deleted by resetting to the factory settings (see chapter 8.2).
9.2.4
Add ibaW-750
There are several ways to add the device in ibaPDA:
Automatically - device is in the same LAN, device search and setup as described
above
Manually - device is not in the same LAN, previous separate device search and
setup
Offline – without connection of a device
9.2.4.1 Automatically
After the device has been configured via the search as in the previous steps, it can be
added to the I/O configuration as a module in ibaPDA.
Select the ibaW-750 device in the
Discovery
tab of the ibaNet-E interface and click the
button
. The device appears in the module tree of the I/O Manager.
Figure 18: Module tree in the I/O Manager
Connected terminals are automatically detected and added as far as possible.
If the device has already been configured for acquisition in ibaPDA, this existing config-
uration is also read out and displayed in the I/O configuration.
9.2.4.2 Manually
If ibaW-750 is not to be operated in the same LAN and therefore cannot be searched,
recognized and added automatically, the device can also be added manually to the iba-
Net-E interface in the I/O Manager.
Click the link
Click to add module…
and select
ibaW-750
.