- 12 -
VII.
Testing
1.
Inspection before use
A.
Check installation of the entire heater and pipe connections according
to the pipe connecting drawing;
B.
Check the electric wiring according to the electric wiring diagram; and
grounding connection;
C.
Make sure that the main heater power switch is off;
D.
Check the temperature setting;
E.
Check the air inlet and outlet.
2.
Trial
A.
The user must Start the water pump before the heat pump, and turn off
the heat pump before the water pump, or the heat pump will be
damaged;
B.
The user should start the water pump, and check for any leakage of
water; Power on and press the ON/OFF bottom of the heat pump, and set
suitable temperature in the thermostat.
C.
In order to protect the pool heat pump, the heater is equipped with a
time lag starting function, when starting the heater; the blower will run 1
minute earlier than the compressor;
D.
After the pool heat pump starts up, check for any abnormal noise from
the heater.
VIII.
Precautions
1.
Attention
A.
Set proper temperature in order to get comfortable water temperature;
to avoid overheating;
B.
Please don’t stack substances that can block air flow near inlet or outlet
area, or the efficiency of the heater will be reduced or even stopped;
C.
Please don’t put hands into outlet of the swimming pool heater, and
don’t remove the screen of the fan at any time;
D.
If there are abnormal conditions such as noise, smell, smoke and
electrical leakage, please switch off the machine immediately and
contact the local dealer. Don’t try to repair it yourself;
E.
Don’t use or stock combustible gas or liquid such as thinners, paint and
fuel to avoid fire;
F.
In order to optimize the heating effect, please install heat preservation
insulation on pipes between swimming pool and the heater. During
running period of the swimming pool heater, please use a
recommended cover on the swimming pool;
G.
Connecting pipes of the swimming pool and the heater should be ≤10m