- 7 -
PERIODICAL MAINTENANCE
Any further adjustments on the refrigerator necessarily require the electric plug to be removed.
Check periodically the supply cable in order to detect any damage. If the power supply cable is damaged,
don't use the equipment and don't try to repair it: to prevent any risk, it must be replaced by the manufacturer,
by a member of the after-sales service staff, or anyway by a person having similar qualifications. In any
case, none of the protective elements (the grill, the carter) must be removed by non qualified staff. Absolutely
avoid using the refrigerator without such protection.
The replacement of neon tube must be carried out only by an Authorized Service Center.
For a good preservation of the cabinet's body
a
periodical cleaning is necessary
.
EXTERNAL BODY
: When necessary, the external
body should be cleaned with a cloth and a
neutral
soap
and water solution.
STAINLESS STEEL SURFACES
: wash with warm water and mild detergent, rinse well and dry with
soft cloth.
Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL
: wash with warm water and mild detergent, rinse well and dry
with soft cloth;
under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES
: only use products specifically designed for glass cleaning;
It is not advisable to
use ordinary water which can leave a film of calcium on the surface of the glass.
Periodically remove from the condenser unit the
impurity (dust and deposit) which remain among
the fins of the condenser, obstructing a good
circulation of the air
.
A dirty condenser reduces the
performance of the equipment, increasing the energy
consumption.
Cleaning should be carried out with a soft brush or
preferably with a vacuum cleaner.
The
manufacturer recommends that this operation
be carried out only by an Authorized Technician.
DEFROSTING AND TANKS CLEANING
Theese units make an automatic defrosting
in the displayng tank.
The
storage compartment
should be defrosted when frost on the walls has a thickness of more than 5
mm.
We recommend to make the defrosting of storage compartment and, at the same time, the cleaning of
displayng tank; proceed as follows:
1) Store all the productc in an other refrigerator at -18°C.
2) Switch off the group using main switch of control panel and unplug the unit.
3) Before cleaning the inside temperature must be equal to the ambient temperature; place a container
of warm but not boiling water inside the storage compartment, standing on a piece of cardboard, and
leave the door closed for about 30 min.
4) Extract the plug inside the tank and the external draining plug; clean the tanks walls with water
and neutral soap, rinse and dry carefully.
5) Clean the tank, rinse and dry carefully.
6) Turn the unit on and 1 hour later you can load the product again.
Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
Never use mechanical devices or any other means to accelerate the defrosting process, other than
those recommended by the manufacturer.
