9
MAN-88 – UK
3.4
INLET SYSTEM INSTALLATION
Pre assembling:
N°2 SCREWS M6x30 INTO THE INLET SPACER AND
TAKE A POSITION OF THE INLET GASKET ENGINE
SIDE AS IN PICTURE.
-POSITION THE PRE-ASSEMBLED INLET SPACER TO
THE ENGINE INLET, COMING TO THE TIGHTEN IN
MANUAL WAY FOR FIXING TEMPORARY THE
SPACER. (SEE LITTLE PICTURE)
AFTER TIGHTEN DEFINITELY THE SCREWS WITH
THE 5MM ALLEN WRENCH
TORQUE AT 6 ÷ 10 Nm (50 ÷ 90 in-lb)
Pre assembling:
N°2 SCREWS M6x95 INTO THE INLET MANIFOLD
AND TAKE A POSITION OF THE CARBURETTOR AS
IN PICTURE.
BETWEEN TO THE INLET MANIFOLD AND
CARBURETTOR POSITION THE GASKET WITH Ø23
HOLE (WITHOUT SMALL HOLES).
TO THE END OF THE CARBURETTOR POSITION THE
OTHER GASKET (Ø19 WITH SMALL HOLES).
-POSITION THE PRE-ASSEMBLED CARBURETTOR
PACK TO THE MANIFOLD INLET AND TIGHTEN THE
SCREWS WITH THE 4MM ALLEN WRENCH.
TORQUE AT 6 ÷ 10 Nm (50 ÷ 90 in-lb)
Fig.6
