35
▼
-> Make Default Gateway: Set the gateway of the IP address as default gateway. There can be
only one default gateway. To remove the default gateway, click
▼
-> Remove Default Gateway.
▼
-> Enable jumbo frames: It can enable the MTU (Maximum Transmission Unit) size. The maximum
jumbo frame size is 3900 bytes. To disable jumbo frames, click
▼
-> Disable Jumbo Frames.
CAUTION:
VLAN ID, jumbo frames for both the switching hub and HBA on host must be enabled.
Otherwise, the LAN connection cannot work properly.
▼
-> Ping host: It can verify the port connection from a target to the corresponding host data port.
Input the host’s IP address and click Start button. The system will display the ping result. Or click Stop
button to stop the test.
▼
-> Reset Port: If the behavior of the port is abnormal, try to reset port to make it normal.
Entity and iSNS Settings
The Entity and iSNS Settings tab is used to view the entity name of the system, and setup iSNS IP for the
iSNS (Internet Storage Name Service) protocol. It allows automated discovery, management and
configuration of iSCSI devices on a TCP/IP network. To use iSNS, an iSNS server needs to be added to the
SAN. When this is done, the iSNS server IP address must be added to the storage system for iSCSI initiator
service to send queries to it.
To make changes, enter the Entity Name and the iSNS IP Address, and then click Apply button.
