i-PRO WV-X35000 Series, Installation Manual

Page: 4 / 120

Precautions for installation
i-PRO Co., Ltd. assumes no responsibility for injuries or property damage resulting from failures
arising out of improper installation or operation inconsistent with this documentation.
„
In order to prevent injury, the product must be securely mounted to an installation surface
according to Installation Guide.
„
Installation area for this product
Select an appropriate place for the installation area (such as a strong installation surface) in your particular
environment.
• Make sure that the installation area is strong enough to hold this product, such as a concrete ceiling.
• Install the camera in the foundation area of the architecture or where sufficient strength is assured.
• Do not mount the product on a plaster board or a wooden section because they are too weak. If the
product is unavoidably mounted on such a section, the section shall be sufficiently reinforced.
„
Do not place this product in the following places
• Locations where a chemical agent is used such as a swimming pool
• Locations subject to moisture or oil smoke such as a kitchen
• Locations that have a specific environment that is subject to an inflammable atmosphere or solvents
• Locations where a radiation, an X-ray, a strong radio wave or a strong magnetic field is generated
• Locations near coasts directly subjected to sea breezes, or locations subject to corrosive gases such
as from hot springs, volcanic regions, etc.
• Locations where the temperature is not within the specified range
• Locations subject to vibrations, such as on vehicles, marine vessels, or above product lines (This
product is not designed for on-vehicle use.) <WV-S35402-F2L><WV-S35302-F2L>
32x02
• Locations near rubber products containing sulfur (packing, rubber feet, etc.)
• Locations subject to condensation as the result of severe changes in temperature such as near the
outdoor unit of an air conditioner. 35x02 35x02M
• Locations where it may get directly wet from rain or water splash (including under the eaves, etc.) 32x02
• Locations subject to moisture or dust 32x02
• Locations subject to sudden changes in temperature such as near air discharge vents of air
conditioners or air circulation inlet doors
32x02
„
Screw tightening
Do not use an impact driver. Use of an impact driver may damage the screws or cause tightening
excessively.
„
About reflection of light from outside or IR light
A ghost may appear on the screen depending on the incident angle of external light.
In the case of using the IR light, installation of a camera near a wall may cause reflection of infrared rays
resulting in a part of the screen or the entire screen turning whitish.
• Refer to our technical information website <Control No.: C0109> for image examples and measures to
take.
„
Take notice of humidity
Install this product when the humidity is low. If installation is performed when it is raining or in very humid
conditions, the inside may be affected by humidity, causing mist-over inside the dome cover.
About notations
35x02
Outdoor, RJ45 conector model (WV-X35402-F2L, WV-X35302-F2L, WV-S35402-F2L, WV-S35302-F2L
35x02M
Outdoor, M12 conector model (WV-X35402-F2LM, WV-X35302-F2LM)
32x02
Indoor, RJ45 conector model (WV-S32402-F2L, WV-S32302-F2L)
„
Install the product in areas that do not receive direct sunlight.
35x02 35x02M
„
This camera is designed to be used indoors
32x02
This product is not operable outdoors. Do not expose this camera to direct sunlight for hours and do not
install the product near a heater or an air conditioner. Otherwise, it may cause deformation, discoloration
and malfunction. Keep this camera away from water and moisture.
4