13
⑴
When the SD ON/OFF button is pressed (less than 1 second), the SD MOUNT indicator lights
up in green and data can be saved to the microSD memory card.
⑵
When the SD ON/OFF button is held down (about 2 seconds), the SD MOUNT indicator lights
off and the microSD memory card can be removed.
⑥
SD ON/OFF button
⑦
ABF (Auto Back Focus) button
Used when adjusting the focus. Refer to the Installation Guide for details.
⑤
SD ERROR/ABF indicator
• When ABF (Auto Back Focus) operation is being executed Blinks red (Interval of 1 time/ second)
• When the camera is being started
Lights red
• When a microSD memory card is recognized normally
Lights red
→
Lights off
• When the SD slot is not used or an abnormality is
Lights red
→
Stays red
detected in microSD memory card after the camera
has started
Note:
• Lighting/blinking LED can be turned off with the software settings at any time. (The initial state
is lighting or blinking.) Set the LED to be solid off if necessary, depending on the installation
conditions. (
☞
Operating instructions on our manual website)
Use the mount base (accessory) when mounting the camera to raise the camera mounting position.
Secure the mount base (accessory) to the bottom side of the camera using 2 fixing screws.
(Recommended tightening torque:0.39 N·m {0.29 lbf·ft})
Size of the mounting hole: 1/4-20UNC mounting hole (depth 9 mm {11/32 inches})
■
Mount base(accessory)
Fixing screws
1/4-20UNC
mounting hole
(depth 9 mm
{11/32 inches})
Mount base
(accessory)
