12
■
Indicators and buttons
①
INITIAL SET button (Initializing / NTSC
⇔
PAL switch button)
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera.
When using a PoE hub, disconnect the Ethernet cable from the camera. When using an
external power supply, disconnect the power cord plug (accessory) from the power supply
terminal (12V DC).
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds.
In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized. Retry if the camera
does not start up normally.
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
•
When the INITIAL SET button is pressed (less than 1 second) to switch the output signal of the
MONITOR OUT terminal, the MONITOR OUT terminal can be switched for the NTSC monitor
⇔
PAL monitor.
②
LINK indicator
③
ACT indicator
• When data is being sent via the network camera
Blinks green (accessing)
• When the camera is able to communicate with
Lights orange
the connected device
④
SD MOUNT indicator
• When a microSD memory card is inserted and could
Lights off
→
Blinks green
→
be recognized
Lights off
• When data can be saved after the microSD memory
Lights off
→
Lights green
card is inserted and the SD ON/OFF button is pressed
(less than 1 second)
• When data can be saved to the microSD memory card
Lights green
• When the microSD memory card is removed after holding
Lights green
→
Blinks green
→
down the SD ON/OFF button (about 2 seconds)
Lights off (recording)
Lights green
→
Lights off
(waiting for recording)
• When data cannot be saved to the microSD memory
Lights off
card because an abnormality was detected or the
microSD memory card is configured not to be used
