CABLINE-UM Instruction Manual
Document No.
HIM-18033-04EN
6
/
15
Confidential C
2．How to Mate
Push the center of cable connector vertically until it clicks.
The clicking shows the mating completion. [Fig. 6]
Push both ends of the connector to make sure the mating is completed. [Fig. 7]
Fig.6 Fig.7
CAUTION
・A support shall be designed and placed under PCB in order to prevent PCB from being deformed
when cable connector is inserted with a pressing.
・The initial connector insertion angle allowance is given in Fig.8. Please set so that it becomes
parallel without applying excessive force afterwards. Do not force to press cable connector when
the insertion angle is out of this allowance angle.
Note 1. One side mating:
Receptacle and plug mating slot side wall are touched on one end
Fig.8 Insertion angle allowance
Then push both connector ends and check the mating
condition to ensure that either end is securely inserted.
One side mating Note 1
Push the center of connector
12° MAX.
One side mating Note 1
One side mating Note 1
12° MAX.
12° MAX.
