19
Picture 2.4. The power connector
Picture 2.5. The Ethernet connector
At the remote location, connect the antenna and bridge unit the regular way. Only
the antenna needs to be connected, the network does not have to be connected.
If you have a directive antenna, aim it at the other antenna.
Figure 2.6 Basic setup of two bridge units.
This diagram is based on a 10Base-T (RJ-45) connection. This connector is
located on the backside of the bridge unit. Picture 2.4 shows the Ethernet
connector. After interconnecting the units, they can be powered up. The power
switch is next to the power connector. See picture 2.3.
