FEATURES OF YOUR HYUNDAI
1- 19
Moving the child closer to the center of
the vehicle may help provide a good
shoulder belt fit. The lap belt portion of
the lap/shoulder belt must always be
positioned as low as possible on the
child's hips, and as snug as possible.
o If the seat belt will not properly fit the
child, Hyundai recommends the use of
an approved booster seat in the rear seat
in order to raise the child's seating height
so that the seat belt will properly fit the
child.
Before purchasing a booster seat, make
sure that it meets applicable Federal
Motor Vehicle Safety Standards and that
it is satisfactory for use with this vehicle.
o Never allow a child to stand up or kneel
on the seat.
o Never use an infant carrier or a child
safety seat that "hooks" over a seatback;
it may not provide adequate security in
an accident.
o Never allow a child to be held in a per-
son's arms while they are in a moving
vehicle, as this could result in serious
injury to the child in the event of an
accident or a sudden stop. Holding a
child in a moving vehicle does not pro-
vide the child with any means of protec-
tion during an accident, even if the per-
son holding the child is wearing a seat
belt.
B230B01E-GAT
Using a Child Restraint System
For small children and babies, the use of a child
seat or infant seat is strongly recommended.
This child seat or infant seat should be of
appropriate size for the child and should be
installed in accordance with the manufacturer's
instructions. It is further recommended that the
seat be placed in the vehicle's rear seat since
this can make an important contribution to safety.
Your vehicle is provided with three child re-
straint hook holders for installing the child seat
or infant seat.
B230B01Y
Cover, Child Restraint
Hook Holder
Bolt, Holder (5/16"-30 mm)
Washer, Conical Spring
Holder, Child Restraint Hook
Spacer, Child Restraint Hook
Holder
Retainer Washer
Spacer, Hook Holder Cover
Rear seat package tray
B230C01E
Tether strap hook
Front of Vehicle
Anchorages
B230C01L-AAT
Installing a Child Restraint Seat with the
"Tether Anchorage" System
Three child restraint hook holders are located
on the rear seat package tray. To install the
child restraint seat, connect the child restraint
tether strap hook to the child restraint hook
holder and tighten to secure the seat.