GB
27 / 39
4.
FOO
D B4 button for selecting the type of food
It is used to set whether you wish to vacuum-pack dry food or moist food.
The setting is indicated by the appropriate indicator light
B5:
Dry = dry food (lights up when the appliance is switched on, indicates the default on state)
Moist = Moist food (not the liquid itself!)
FUNCTION INTERRUPTION
To interrupt an activated function, it is necessary to press the
B2
button.
USE
(Fig. 2)
Connect the appliance to the mains.
1.
Press
A2
button and open the lid
A1
.
2.
Put foil/bag into the sealer with the open part ahead (into the exhaustion section).
If you
make a bag from a bag roll (both ends are unsealed), first put the bag in the sealer
so that its end does not reach the vacuuming area, and then seal it! Then seal/
vacuum the other end (after the bag is fulfilled) in the standard manner.
3.
Close the lid
A1
and push the lid edges down to lock it (a click will be heard).
4.
Press the button with the required function (
B1, B2
or
B3
). The operation of the function
is signaled by the LEDs
B6, B7
and
B8
.
5.
When the light goes out, the welder's function is complete. You may open the lid
A1
(first press
A2
button) and remove the foil/bag.
Note
–
If sealing function is activated, air is exhausted for a short time.
–
When using hose
C
with reusable bags, follow the preview in figure 1 (connect the
hose to hole
A7
and use function
B3
).
Notice
–
Proper functionality of the appliance is assured only when using the foils/bags supplied by
the manufacturer. Request these foils at your retailer. Do not use plastic bags. At the same
time you can re-weld many foods in their original packaging (eg bags of potato chips).
– The vacuum sealer is used to seal cling foil up to the max. width of 300 mm.
IV. CARING FOR YOUR VACUUM SEALER
Do not clean appliance if is hot.
After each use, wipe the outer parts with a damp soft
cloth. To clean the inner parts of the appliance, wipe all pieces of food and liquids with
a paper cloth. Leave to dry properly before next use.
Do not use abrasive and agressive
cleaning agents!
If the power cord becomes stained, wipe it with a damp cloth. The colour
change of the surface in time is normal. This change does not change the qualities of the
surface in any way and is not a reason to return this appliance! If particles of plastic adhere
to the sealing wire, wipe them off carefully to avoid damage to the wire. If can help to carry
out a sealing operation the lid and pressing fully down without a bag in position. This will
heat the wire and soften any plastic adhering to it.
BAGS
Before reusing a bag, we recommend properly washing it in warm water with a small
amount of dishwasher detergent, and rinsing in clear water. Place the bag so that water
can flow out from inside the bag. Before reusing, dry the bag thoroughly.