![background image](http://html1.mh-extra.com/html/hyundai/si-267/si-267_instruction-manual_2196577033.webp)
ENG - 33
ENG
Recommendation
Control
H
(Fig. 2) is marked with international symbols that recommend the optimum ironing
temperature and they are the same as marking on some types of laundry and textiles (Fig. 3).
Steam ironing
Hold the iron in your hand, turn the steaming regulator
D
to the position
OFF
(Fig. 5) and slide
the cover
C
to open the filling container lid. Pour in water to the container
I
(Fig. 4) with the
enclosed cup
O
and close the filling hole lid in the opposite direction. Keep the position of the
iron for pouring in water. Put the iron to the rest position (Fig. 7) and set the regulation wheel
H
to the marked area for steaming (Fig. 2 - ). Plug the power cord
M
to a socket. When the
control light
G
turn from red into the green light, move the steaming regulator
D
away from
handle. The more you move the regulator towards
MAX
, the bigger amount of outgoing steam
there will be (Fig. 5). Place the iron to the rest position, automatic creation of steam will stop
(more steam may be going out for a short time).
Warning
•
For all normal ironing the middle adjustment of the steam amount is recommended. Only
on ironing the linen fabric, thick cotton and similar fabrics the adjustment of the steam
amount to maximum value is recommended. Setting to high-pressure steam ironing os
recommended only if the regulation wheel
H
is set to temperature setting •••.
• Be extra careful to avoid accidental pushing of the
SELF CLEAN
button.
• When water container I is filled with water over the permitted limit (
MAX. 300 ml
), steam can
be created even in the rest position.
• At places with hard water we recommend diluting it with distilled water. You will get the
information about water hardness at the water-management authorities, or at the local
sanitary station.
For water hardness
> 15 °N
we recommend filling the iron in the following ratio:
Water hardness
Ratio of tap water : distilled water (pH = 7)
medium
2 : 1
hard
1 : 1
very hard
1 : 2
Please note
•
Use tap water only. Distilled and/demineralised water makes the anti-calc system ineffective.
• Failure to comply with the above-mentioned regulations leads to the loss of guarantee.
Sprinkling appliance (additional spray)
It is used for moistening fabrics and it is effective in ironing extremely creased fabrics. It is
activated by repeated pressing of additional spray button
E
. We do not recommend applying
additional spray for fine fabrics (e.g.
silk and synthetic
) as the used water may stain the fabric.
Intensive steaming (steam shock)
Use only if the steam ironing is insufficient. In this case press intensive steaming button
F
several times (Fig. 6A -
). Thus you will get additional steam except for the steam created by
standard steaming. If you wish to use the steam shock button, set the thermostat regulation ring
H
to max. For even more intensive steam shock, set the steam regulator
D
to position
OFF
(turn
it back to your desired position afterward).
Warning
•
An intense „burst“ of steam penetrates deep into the fabric. For optimum steam quality, leave
an interval of at least four seconds between pressing the Surge of Steam button.
Summary of Contents for SI 267
Page 46: ...Pozn mky Notatka Notes...
Page 51: ...Pozn mky Notatka Notes...