Hyundai SI 160, Instruction Manual

Page: 26 / 36

ENG - 26
DRY-IRONING
Turn the steam selector to position pic.3 this shuts off the
steam flow, should there be any waterin the tank. Select the
temperature setting most suitable for the fabric to be ironed.
Once the temperature has been reached, ironing may com -
mence. Ensure that there is sufficient water in the water tank
if you wish to use the spray facility occasionally while dry-iro -
ning. If dry-ironing for longer than 20 minutes, the water tank
should be emptied to prevent over heating of any water pre -
sent.
STEAM-IRONING
As per the indications on the temperature dial and the table A (see section „Setting the tempera -
ture“) that steam-ironing is only possible at higher ironing temperatures.
- Plug into the mains supply and switch on.
- Set the temperature dial at the required positron within the steam area ( or ) and wait until
the heating indicator light has gone out.
- Set the steam selector to the requiredsetting. You can then begin steam ironing.
SURGE OF STEAM
The Surge of Steam provides an extra burst of steam which
is ideal for removal of stubborn creases and wrinkles during
STEAM or DRY ironing.
- Turn the temperature setting to the hottest setting within the
steam area and wait until the heating indicator light goes out.
- Lift the iron slightly above the surface of the fabric, press the
Surge of Steam button down firmly and then release it during
ironing (Fig.4).
An intense „burst“ of steam penetrates deep into the fabric.
For optimum steam quality, leave an interval of at least four
seconds between pressing the Surge of Steam button.
NOTE: The Surge of Steam can be used when the Steam Selector is in maximum setting.
SPRAYING
Spray may be used to dampen difficult fabrics,dry areas,wool
items and accidental creases.
Press the spray button firmly to produce a fine spray of water
ahead of the iron, and continue ironing Fig 5.
Spray may also be used with delicate (synthetic) fabrics which
are ironed at a low temperature and thus cannot be steam-
ironed.
Warning:
For delicate fabrics, we recommend moistening the fabric
beforehand using the spray function, or putting a damp cloth
between the iron and the fabric. To avoid staining, do not use
the spray on silk or synthetic fabrics.