26 / 45
A4 – heat-insulated handle
A8 – safety fuse ON button
B – control panel
B1 – display
B2 – temperature regulator and simultaneously START/STOP button
B3 – timer regulator
Over-heating protection
The preserving pot is equipped with a safety heat switch which will disconnect the heating body
in case of insufficient or no amount of water. If there is insufficient water in the preserving po
t
, an
alarm sounds and a flashing symbol will display of a pan filling with liquid (upper left hand side
of timer screen). Immediately add more water to a level sufficient for the process being performed.
If water is not added the preserving pot
will automatically turn off and must be allowed to cool.
Caution:
f the appliance does not work after having been connected to the el. outlet, press
button
A8
. The button is on the bottom of the appliance.
PREPARING FOR USE
Remove all packaging material and remove the appliance with accessories. Remove all adhesive
foils, stickers or paper from the appliance. Wash all parts, which will come in touch with food in hot
water with soap, rinse them thoroughly with clean water and wipe dry or let dry before first use.
Make sure that the power supply cord is not damaged and that it is not led underneath the
appliance or over any sharp or hot surfaces. The socket must be readily accessible so that the
appliance could be easily disconnected from the mains in case of danger. Pour clean drinking
water into the appliance up to about 6 liters. Set the temperature regulator
B2
into “
100
” position
and the timer regulator
B3
into “
30
” position. Wait until the water reaches boiling point and let it
boil for at least 10 minutes. Let the appliance cool off and pour out the water. Potential short and
moderate smoke or smell is not a fault and a reason for taking the appliance back.
Place the appliance on a solid flat and dry surface (e.g. kitchen table),out of reach of children.
If you are going to use the appliance for preserving in jars, insert the removable grid
A6
and fill the
container with sufficient volume of water, depending on the character and amount of the prepared
food. Plug the fork of the power supply
A7
in the el. plug. The preserving pot is now ready for use.
INSTRUCTIONS FOR USE
Display
After correct assembling and connecting the appliance to the mains, display will light (the shows
the basic settings “80 30” (i.e. temperature / time) and then the pot is switched automatically to the
stand-by regime after 10 sec. The left hand side of the panel shows the set temperature (upper)
and current temperature (lower) in degrees Celsius. The right hand panel shows the time set in
minutes.
Temperature setting
The appliance is equipped with an in-built thermostat, which enables you to set the temperature
from approx. 100 °F to 212 °F (boiling point) with ± 8 % accuracy. When reaching the set
temperature, it is automatically maintained (depending on the setting of the timer).
Setting the timer
T
he timer enables you to set time in the range of 1 – 180 minutes. To increase the time desired,
turn the regulator clockwise. To decrease it, counter-clockwise. When the set time runs out, the
appliance turns off.
The process of preserving in a few steps
1) Insert the removable grid
A6
on the bottom of the container
A3
.
2) put in the mason jars (see Tips).
3) fill the container
A3
with the necessary volume of water.
