4
f
o
3
e
g
a
P
STEP 2 Installing the FM Modulator (Contd.)
d. Connect black wire to lower metal cross brace
(has existing factory ground wire in this location).
Loosen bolt and slide spade connector in and tighten bolt.
a. Remove storage bin by removing (4) mounting screws.
b. Drill 3/4’’ hole in the back left side of storage bin below
AC controls, as viewed from back of the unit.(Fig.1)
c. Route RCA and power plug through drilled hole.
d. Drill (2) 3/32’’ on the places marked (X) on the above
illustration.(Fig.4, See last page for template of proper
location on where to drill holes).
STEP 3 Installing the Jack Connector Switch Plate
STEP 3 Installing the Jack Connector Switch Plate (Contd.)
e. Make sure you plug in both RCA and power plugs to FM
Modulator and wrap with felt.
f. Carefully secure modulator harnesses to prevent rattles
using the 8’’ wire ties.
g. Once all connections have been made place the pocket
divider over the outside wall of the switch plate.(Fig.2)
a. Reconnect radio and AC controller wire harness
connectors.
b. Secure radio/ AC assembly with the (10) screws previously
removed.
c. To eliminate potential rattles be sure to check proper
installation of the white retainer clips.Snap side panels
back in place.
d. The installation is now complete.
e. Place User Instruction Sheet and 24’’ Audio Cable into
glovebox.
STEP 4 Re-Installing the Radio/ Vent Panels
10mm Socket
Connector
Switch Plate
Back view of storage bin
7
0
/
/05
4
............................................x
x
Drill
Drill
Fig.1
Fig.4
SEE PAGE 4
x
x
............................................
Drill
Drill
Actual Size
