Step 1.
Place bin illustration template over the actual bin of the vehicle. (See Fig.4)
Be sure to align the boxed diagram directly onto the bin.
Hint:
Feel around on the boxed area on the bin illustration to check if the template is aligned to the bin as best
as possible.
Step 2.
Cut out the
dotted
lines on the illustration so that the brackets fit through to align the bin template.
Step 3.
Using a drill, drill (2) 3/32’’ holes where the template is marked with an “X”.
Note:
Be sure to drill all the way through the top wall of the bin.
Step 4
. Place Jack Connector Switch Plate against the right hand side wall and behind the felt line. (See Fig.3)
Step 5.
Using a drill, screw in the supplied screws through the bin and switch plate, be sure to hold pressure on the switch plate.
Step 6.
Apply tune label to the inside of the bin door. (See note in Fig.3)
4
f
o
4
e
g
a
P
7
0
/
/05
4
FIG. 4
x
x
Drill
Drill
Actual Size
TOP VIEW OF BIN
FIG. 3
FRONT
REAR
Template Instructions (Step 3c)
Pocket Divider
Veracruz Storage Bin Drilling Template
Tune Label
Location
Tune Radio to 88.3MHz
FIG. 2
