Hyundai HYU HC666, Instruction Manual

Page: 13 / 28

straightener. Then close the hair straightener by pushing and move it slowly on the lock
from roots towards hair tips. You can curl the tips thanks to round edges of the plates
upwards or downwards. Repeat the process till you have created the required hairstyle. Let
the hair cool down before the final styling.
Replacing attachment for straightening and shaping hair
Press release button (A11) to replace the atachments Pull the attachments gently out (on
both sides of the pliers) and put on the desired attachment reversely. These attachments
are double-sided If you currently have ironing plates and you wish to replace them with
crepe attachment, you may only slide the attachment out, turn around and slide back on.
The attachment is ready to use after an audible click.
The curling iron A5
Take a strand of hair, maximum 3 cm wide, open the curling tong and place the ends of
the strand on the tong and clamp tight by closing the curling tong. Now turn the appliance
so that the strand of hair is rolled up to the roots. Hold the appliance in this position for
approximate 20 seconds, maintaining sufficient distance between scalp and curling tong.
Then carefully unwind the strand half way, open the curling tong and release the curl gently
from the tong.
Note:
Additional attachments can be attached to the hot-comb pliers A5 for more variable hair
styling Attachment A7-1 is accessory which is not intended for attaching to the hot-comb
pliers but on the main body of the hot comb and is used individually.
Attaching and replacing attachments
For attaching and replacing attachments proceed followingly:
- Push gently to attach the desired attachment.
- The arrow placed on the main body A must be directed towards an emplty arrow ,
which is placed on the arrest ring A3 in order that the parts fit in.
- Turn the arrest ring A3 in such a way that the full on the arrest ring is directed against
the full . arrow on the main body.
- The appliance is ready for use
- Proceed reversedly when taking the atachments off.
Slide the A7-2 attachment on the pliers in such a way that the protrusion of the attachment
fits into the arrest protrusion on the pliers (pic.2).
Caution:
Let the attachments cool off before replacing. Never replace the attachments while they
are hot!
IV. MAINTENANCE
Turn off the appliance before any maintenance, disconnect it from power supply by
unplugging the power cord from the electric socket and let it cool down! Do not use
rough and aggressive detergents (e.g. sharp objects, scrapers, diluting agents or
other solvents)!
Treat the surface with a wet and soft cloth.
Put the cooled straightener to a safe and dry place, out of reach of children and
incapacitated persons.
13
GB