![background image](http://html1.mh-extra.com/html/hyundai/hy6222/hy6222_user-manual_2196078017.webp)
6.4.2.
The chain oil flow can be altered by inserting a screwdriver in the hole (1) on
bottom of the clutch side. Adjust the oil flow according to your work
conditions.
The chain oil tank should be nearly empty by the time the fuel is used up.
Make sure that you refill (or top up) the chain oil tank every time the unit is fueled.
6.5.
Carburetor adjustment.
6.5.1.
The carburetor on your unit has been factory adjusted, but may require fine
tuning due to changes in operating conditions. Before adjusting the
carburetor, make sure that the air/fuel filters are clean and free of any debris,
properly mixed fuel. When adjusting, take the following steps;
6.5.1.1.
Stop engine and allow it to cool then screw in both
H
(2)
and
L
(1)
needles until they stop, DO NOT apply excess pressure when doing this.
6.5.1.2.
Then set them back the initial number of turns as shown below.
6.5.1.2.1.
H
(2) needle 1
3
/
8
6.5.1.2.2.
L
(1) needle 1
1
/
4
6.5.1.3.
Start the engine and allow it to warm up at half throttle.
6.5.1.4.
Turn the
L
(1)
needle slowly in a clockwise direction to find a position
where idling speed is maximum, then set the needle back a quarter (¼)
turn the screw counter clockwise.
6.5.1.5.
Turn the idle adjusting screw
T
(3) counter clockwise so that the saw
chain does not turn. If idling speed is too slow, turn the screw clockwise.
6.5.1.6.
Make a test cut and adjust the
H
(2) needle for best cutting power, not
for maximum speed.
Page 17
Rev 2
Summary of Contents for HY6222
Page 1: ...PETROL CHAINSAW MODEL HY6222 User Manual...
Page 29: ...Page 29 Rev 2...
Page 30: ...Page 30 Rev 2...
Page 31: ...Page 31 Rev 2...