11
3.5
Carefully pour petrol into the fuel tank.
NOTE:
This is a 4 stroke machine so
DO NOT
mix fuel with oil.
3.6
Leave a 25mm gap between the fuel and the top of the fuel tank.
3.7
Replace the fuel filler cap and tighten securely.
3.8
Wipe up any spills immediately.
WARNING
This machine is shipped without oil and fuel.
You
MUST
ensure all fluid levels are correct before operation otherwise you may
cause serious engine damage that will not be covered by the warranty.
4.0
Place the machine on flat level ground before starting.
4.1
Turn the ignition switch to the ‘I’ ON position.
4.2
Slowly press the primer bulb 5 to 10 times.
NOTE
: After the 7
th
press, fuel should be visible in the primer bulb.
If it is not, continue to press the primer bulb until you see fuel in the bulb.
4.3
Push the choke button in, to set the choke to FULL CHOKE position.
NOTE
: Do not squeeze the throttle trigger because the choke will pop out
automatically.
4.4
Pull the recoil starter handle until you feel resistance.
Once you feel resistance, pull the recoil starter handle swiftly 3 to 5 times or until you
hear the engine turn over or begin to start.
4.5
Allow the engine to run for 10 seconds then squeeze the throttle to release the choke
in to the RUN position.
4.6
Place the machine on flat level ground before starting.
4.7
Turn the ignition switch to the ‘I’ ON position.
4.8
Ensure the primer bulb has fuel inside.
4.9
Pull the recoil starter handle until you feel resistance.
Once you feel resistance, pull the recoil starter handle swiftly 3 to 5 times or until the
engine starts.
5. STARTING PROCEDURE
FROM COLD
FROM WARM
