Hyundai HWC-M100, User Manual

Page: 16 / 42

RF Data Modem HWC-M100 / HWC-W100 / HWC-W120
14
2.3 Configure the Setting of RF-Modem(HWC-W100)
< Front View >
< Rear View >
∎ You can configure Net-ID, Device-ID and Mode of RF-Modem using switches. And you can
confirm the configuration information in special GUI. The debug-port supports RS-232C
interface(57600 bsp, 8 bit data, None parity, 1stop).
Pin Number Description
1 TXD
2 RXD
3 GND
< Pin description of Debug-Port >
∎ RF-Modem relays data in which Host delivers to the End-Device by wireless. And It can
be used as AP(to communicate with Host) or EP(to communicate with End-Device) by selection
of dip-switch in front panel of it.
∎ In AP-mode, you need to set Net-ID, Device-ID, AP/EP-Mode as follows:
- NET-ID : Network Number. Each network has its own unique frequency band.
and you can select one of the 16 network.(Net.ID : 0~15)
- DEVICE-ID : Device-ID of the AP. Each AP has its own unique number in a network.
and you can select one of the 20 APs.(Device-ID : 0~19)
- AP/EP-Mode : You must turn the dip-switch for AP/EP-mode to ON.
∎ In AP-mode, you need to set Net-ID, Device-ID, Baud-rate, data-bit, stop-bit,
parity-bit, interface-type and AP/EP-Mode as follows: