RF Data Modem HWC-M100 / HWC-W100 / HWC-W120
12
2.2 Configure the Setting of RF-Master(HWC-M100)
< Front View >
< Rear View >
∎
DEBUG : You can configure RF-Master through the debug-port using special GUI in PC or
notebook. The debug-port supports RS-232C interface(57600 bsp, 8 bit data, None parity,
1stop).
Pin Number
Description
2
TXD
3
RXD
5
GND
< Pin description of Debug-Port >
∎
RF-Master has two ethernet network. One is to link the upper Host, another is to link
the lower APs.
∎
UP-LINK : RF-Master could be connected using LAN cable with upper device(HOST)
through RJ-45 connector(UP-LINK) in rear panel of device.
∎
LOCAL-LINK : This port(LOCAL-LINK) is used for communication with lower device(AP).
RF-Master has 2 channel Ethernet hub inside in it. So you can extend APs without any
external Ethernet hub.
∎
Ethernet communication between HOST and RF-Master(UP-LINK) can be implemented in
public or private network. and AP can use in the private network that configured in
production.
Each ethernet network is configured as following:
Summary of Contents for HWC-M100
Page 1: ...RF Data Modem HWC M100 HWC W100 HWC W120 User Manual...
Page 6: ...RF Data Modem HWC M100 HWC W100 HWC W120 4 1 3 Product Description RF Master HWC M100...
Page 8: ...RF Data Modem HWC M100 HWC W100 HWC W120 6 RF Modem HWC W100...
Page 10: ...RF Data Modem HWC M100 HWC W100 HWC W120 8 RF Modem HWC W120...
