![background image](http://html.mh-extra.com/html/hyundai/hc-103/hc-103_instruction-manual_2196459023.webp)
EN - 23
EN
TO TURN THE CLIPPER OFF
Either: press the ON/OFF button ,the unit will shut down completely and adjust the wheel to make
sure the cutting guide return to its original position .
To remove the cutting guide, first adjust the cutting length to 3mm or 21mm and push the guide
out of the support lifting it up with your thumb. (Fig. 4)
CUTTING TECHNIQUES AND ADVICE FROM THE EXPERTS
• Use the clipper on clean,dry hair.
• To familiarize yourself with the clipper,begin with the cutting guide for a longer cut,adjust it by
sliding the wheel.You will soon know the lengths of each guide and each position.
• Always move the clipper against the direction of hair growth.
• Begin at the nape.Place the guide on the scalp and move the clipper toward the crown of your
head.Move your clipper slowly, pointing the teeth of the guide slightly upward. Keep the clipper
in contact with your head at all times.(Fig. 5)
• For the crown of the head,move from front to back,that is ,from your forehead to the crown of
your head.
• For the finishing touches,that is,around the nape and sideburns,use the clipper without a cutting
guide.Turn your clipper over and move it from top to bottom.(Fig. 6)
• If you want a lengh greater than 30 mm,or if you are experienced,you can create “comb” or
“finger” cuts:
- Work without a cutting guide.
- Take up a small section of hair with a comb or in your fingers.
- Move the comb or your fingers along the section of hair to the desired length.
- Cut your hair along the coomb or your fingers.
- Remove the cut hair using a comb and check the eveness of the cut regularly.(Fig.7)
USING THE THINNING GUIDE
Switch the clipper to the “THIN” position.The thinning guide is in front of the blades. This technique
allows you to thin out hair to make styling easier. The technique is particularly good for the crown
of the head where hair is usually thicker. To thin your hair ,take a section of hair (rest your little
and ring finers on your scalp,using the middle and index fingersto set the length),hold 1 to 2 cm
below the cutting length. Then,using the clipper ,cut the section of hair steeply and at an angle to
create a sawtoothed “edge”.
MAINTENANCE
• Remove the cutting guide after each use.
• Cleaning the clipper blades regularly will maintain their optimal performance.
• Removable blades
• To make cleaning easier,the clipper blades can be removed.Make sure the clipper is turned off.
Hold the clipper with the blades pointing up and remove them by pressing the top of the blade.
(Fig. 8)
• Brush the blades using the cleaning brush to remove any hair.
• It is nevertheless recommended that your put oil to blade,when you notice the clipper isn’t
performing as well.
• Remove the blades as described above.
• Carefully squeeze a few drops of oil onto the pad.
• Then put the blades back on the clipper.
• Oil is specially formulated for clippers,it will not evaporate or slow the blades down .
• You can get new blades when these are worn or damaged.