EN - 22
CHARGING THE CLIPPER
Before using the clippers for the first time,charge for 16 hours.
The charging cord can be put in the stand (Fig. 1)
1) Plug the transformer into the mains.
2) Place the clipper in the stand.Always check that the indicator light is on when the clipper is in
the stand.
3) When fully charged,you will be able to use the clipper for up to 45 min.
The charging cord also can put into the mains for charging .(Fig. 2)
USING THE CUTTING GUIDES
IMPORTANT:
Always attach the cutting guide BEFORE turning the clipper on and turn the clipper
off to change guides.
The cutting guide is very pratical and guarantees an even cut . To attach a cutting guide, first adjust
the cutting length to 3 mm or 21 mm and place it on the support guide adjusting first both sides
and pushing on the bottom of the guide until you hear a “click”. (Fig. 3)
NOTE:
The precision guide must be placed like the cutting guides but it is adjusted manually and
independently of the grooved wheel.
STARTING AND USING
To adjust the clipper’s cutting length, turn the grooved wheel up or down.
The selected length is displayed on the right or left side of the clipper.
Press the ON/OFF button.
You can change the cutting length at any time.
Thanks to the smart adjusting system,the length of the cut is maintained even if the angle
of the clipper varied, so it guarantees precise result.
