![background image](http://html1.mh-extra.com/html/hyundai/dtc-657-dw8f/dtc-657-dw8f_instruction-manual_2196236121.webp)
EN - 121
EN
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4 (inch)
connector and make sure that it is fastened tightly in place.
Water pressure 0.04 – 1.0 MPa. If the water pipes are new
or have not been used for an extended period of time, let
the water run to make sure t hat the water is clear and free of
impurities. If this precaution is not taken, there is a risk that the
water inlet can get blocked and damage the appliance.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind
it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with
water supply and drain hoses that can be positioned to the right or the left to facilitate
proper installation.
Levelling the Appliance
▪ Dishwasher must be level for proper dish rack operation and wash performance.
▪ Place level on door and rack track inside the 1 tub as shown to check that the
dishwasher is level.
▪ When level the dishwasher, please pay attention not to let the dishwasher tip over.
Drain hose Connection
▪ Insert the drain hose into a drain pipe with a minimum diameter of 40 mm, or let it run
into the sink, making sure to avoid bending or crimping it. Use the special plastic support
that comes with the appliance.
▪ The free end of the hose must be at a height max. 600 mm and must not be
immersed in water.
Drain pipe
Front
Counter
NOTE
The top of the hose must
be less than 600 mm
Summary of Contents for DTC 657 DW8F
