Hyundai DTC 657 DW8F, Instruction Manual

Page: 116 / 164

EN - 116
EN
Starting a cycle wash
1. Draw out the basket, load the dishes and push them back.
2. Pour in the detergent (see the section e`ntitled Salt, Detergent and Rinse Aid).
3. Insert the plug into the socket. The power supply is 220 – 240 V AC / 50 Hz, the specification
of the socket is 10 A 250 V AC. Make sure that the water supply is turned on to full pressure.
4. Close the door, press the ON/OFF button, and the ON/OFF light will turn on.
5. Press the program button. If a program is selected, the response light will light. Then
press the START/PAUSE button, the dishwasher begins to wash.
WARNING!
When you press the START/PAUSE button to pause during washing,
the program light will stop blinking and the dishwasher will mooing every
minute unless you press the START/PAUSE button to start.
Change the Programme
▪ You can modified the washing program, just the dishwasher has been running for a short
time. Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case, the detergent dispenser must be
refilled (see the section entitled “Loading the Detergent”).
▪ Press the Start/Pause button to pause the washing. Press Program button for more than
3 seconds - the program will cancel. Press the Program button to select the desired
program. Press the Start/Pause button, after 1 seconds, the dishwasher will start.
3 sec
Note
▪ If you open the door during a wash cycle, the machine will pause. The program light will
stop blinking and the buzzer will mooing every minute unless you close the door. After
you close the door, the machine will keep on working after 10 seconds.
The program lights show the state of the dishwasher
▪ One of the program lights on,you can choose program → stand by
▪ One of the program lights on → pause
▪ One of the program lights blinking → run
Forget to Add a Dish?
A forgotten dish can be added any time before the detergent cup opens.
1. Press the start/pause button.
2. Open the door a little to stop the washing.
3. After the spray arms stop working, you can open the door completely.
4. Add forgotten dishes.
5. Close the door.
6. Press the start/pause button.The dishwasher will work after ten seconds.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.