Hyundai DTC 657 DW8F, Instruction Manual

Page: 105 / 164

EN - 105
EN
Water Hardness level
Setting on the
water softener
Digital display stalls
°dH
1)
mmol/l
2)
0 – 5 0 – 0.9 1 H1 (Rapd)
6 – 11 1.0 – 2.0 2 H2 (90min)
12 – 17 2.1 – 3.0 3 H3 (90min, Rapid)
18 – 22 3.1 – 4.0 4* H4 (Glass)
23 – 34 4.1 – 6.1 5 H5 (Glass, Rapid)
35 – 55 6.2 – 8.0 6 H6 (Glass, 90min)
1)
German degree of measurement for the water hardness
2)
millimol, internationel unit for water hardness
*)
factory setting
There are 6 levels of salt consumption in total
1. When you push START/PAUZA button, digital display stalls of information. Press
START/PAUZA button every time, stalls by “H1 – H2 – H3 – H4 – H5 – H6 – H1” cycle
of change
2. In setting mode, don‘t press any button minimaly for 5 sec, in order to exit the settting
mode, the machine will get into standby
3. Then you can select a program to start your machine.
Water softener
▪ The hardness of the water varies from place to place.
▪ If hard water is used in the dishwasher, deposits will from on the dishes and utensils.
▪ The appliance is equipped with a special softener that uses a salt specifically designed
to eliminate lime and minerals from the water.
Loading the Salt into the Softener
▪ Always use salt intende d for use with dis hwasher.
▪ The salt container is located beneath the rack and should be filled as follows:
ATTENTION!
Only uses alt specifically designed for use in dishwa shers! All other types of
salt not specifically designed for use in a dishwas her, especially tablesalt, will
damage the water softener. In case of damage s ca used by the use of unsui
tabl e salt the manuf acturer does not give any warranty or is liable for any cause
damages. Only fill withs alt just before starting one of the complete washing
programmes. This will prevent any grains of salt or salty water, which may have
been split, remai ni ng of the bottom of the machine for any period of time, which
may cause corrosion. After the first wash cycle the control panel light expires .