EN
EN - 55
ADJUSTINg SALT CONSUMPTION
Step 1: Enter the status of salt adjustment
Close the door, within 60second after power on,press Rapid button for 5 seconds at the same
time,then enter setting mode. Digital display stalls “H *“, the controller factory default H4
Step 2: select a certain level of salt consumption
Different programs stand for different level of salt consumption.
It is recommended to select this level according to below table:
water hardness level
Setting on the water softener
Digital display stalls
°dH
1)
mmol/l
)
0 - 5
0 - 0,9
1
H1
6 - 11
1,0 - 2,0
H2
1 - 17
2,1 - 3,0
3
H3
18 -
3,1 - 4,0
4*
H4
3 - 34
4,1 - 6,1
5
H5
35 - 45
6,2 - 8,0
6
H6
Note:
German degree of measurement for the water hardness
millimol, internationel unit for water hardness
*) factory setting
There are 6 levels of salt consumption in total
When you push Rapid button, digital display stalls of information. Press Rapid button every
time, stalls by “H1 - H2 H3 - H4 - H5 - H6 - H1“ cycle of change
In setting mode, press the Delay button, or 60s there is no change in stalls (program key)
operation, then exit the set mode, the machine isinto standby status.
Then you can select a program to start your machine.
wATER SOFTENER
The hardness of the water varies from place to place.
If hard water is used in the dishwasher, deposits will from on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt specifically designed
to eliminate lime and minerals from the water.
1)
)
1)
)
3)
