• If voice recognition is in [Expert Mode],
then the system will only say a “Beep~”
• To change the Normal Mode/Expert
Mode setting, go to [SETUP]
▶
[System]
▶
[Prompt Feedback].
Starting Voice Recognition
Using Voice Recognition
Shortly press the [VR] key on the steering
remote controller
▶
Say a command
The prompt message is immediately
ended and the beep tone will sound. After
the “beep”, say the voice command.
If voice recognition is in [Normal Mode],
then the system will say “Please say a
command. Beep~”
While prompt message is being stated
▶
Shortly press the [VR] key on the steering
remote controller (under 0.8 seconds)
The command wait state is immediately
ended and the beep ton will sound. After
the “beep”, say the voice command.
While system waits for a command
▶
Shortly press the [VR] key on the steering
remote controller (under 0.8 seconds)
• For proper recognition, say the
command after the voice instruction and
beep tone.
Skipping Prompt Messages
Re-starting Voice Recognition
4 Voice Recognition
Starting Voice Recognition
Information
