![background image](http://html1.mh-extra.com/html/hyundai/accent-gl-2002/accent-gl-2002_manual_2196318101.webp)
Fig. 91: Positioning Piston Ring End Gaps
Courtesy of HYUNDAI MOTOR CO.
9. Install the upper main bearings in the cylinder block.
10. Install the lower main bearings in the main bearing caps.
11. Make sure that the front mark of the piston and the front mark (identification mark) of the connecting rod
are directed toward the front of the engine.
12. When a new connecting rod is installed, make sure that the notches for holding the bearing in place are on
the same side.
13. When assembling, bolts should be fastened by the angle - torque controlled method as the following.
1. Apply oil to the thread of nuts and spot areas.
2. Tighten the connecting rod bolt.
Tightening torque
Connecting rod cap nut:
32-35 Nm (320-350 kg.cm, 24-26 lb.ft)
CAUTION: After removing the connecting rod bolt, do not use if again.
When using a new bolt, do not tighten the bolt more than 3
2002 Hyundai Accent GL
2002 ENGINE Engine Mechanical System (DOHC 1.6L) - Accent
viernes, 19 de febrero de 2021 07:12:59 a. m.
Page 101
© 2011 Mitchell Repair Information Company, LLC.