CONNECTING RODS
1. When the connecting rod cap is installed, make sure that the cylinder numbers, marked on rod end cap at
disassembly, match. When a new connecting rod is installed, make sure that the notches holding the
bearing in place are on the same side.
2. Replace the connecting rod if it is damaged at either end of the thrust faces. If it has a stratified wear in,
or if the surface of the inside diameter of the small end is severely rough, replace the rod.
Fig. 86: Locating Connecting Rod Notches
2002 Hyundai Accent GL
2002 ENGINE Engine Mechanical System (DOHC 1.6L) - Accent
viernes, 19 de febrero de 2021 07:12:59 a. m.
Page 96
© 2011 Mitchell Repair Information Company, LLC.
