2
√
×
×
LED Indication
Charging Status
The LED Indicator flashes red
slowly.
Standby (no load)
The LED Indicator glows red.
Charging
The LED Indicator glows orange. 90% charged
The LED Indicator glows green.
Fully charged
The LED Indicator flashes red
rapidly.
Charging failed
Attaching the Battery
Note: To remove the battery, turn off the radio
first. Then slide the battery latch upwards to
unlock the battery and remove it.
Checking the Battery Power
You may check the current battery power by holding
down the programmed
Battery Power Indicator
key
preset by your dealer. And release the key to exit. Battery
power indications are listed below:
LED Indication
Icon
Battery Power
The LED Indicator
glows green.
High
The LED Indicator
glows orange.
Medium
The LED Indicator
glows red.
Low
The LED Indicator
glows red and low
battery alert beeps.
Under the low battery
threshold. Please recharge
or replace the battery for
proper radio operation
Attaching the Antenna
Caution: Do not hold the radio by its antenna,
otherwise the performance and lifespan of the
antenna will be reduced.
Attaching the Belt Clip
1. Loosen the screws from the back of the radio.
2. Align the screw holes of the belt clip with those on the
radio’s back, and then tighten the screws.
Attaching the Accessories
1. Open the accessory connector cover as shown below.
2. Align the accessory (such as an audio accessory,
or a programming cable) plug with the accessory
connector.
Caution: Do not scrape the silicone rubber
surrounding the accessory connector screw
hole, in order to ensure the waterproof
performance of the radio.
3. Tighten the screw on the accessory plug.
"Click"
