24
© Copyright 2018 HYPERVSN. All rights reserved
8.
Join the plate and bracket together by tightening the left and right screws (
) into the weld nuts until fully tightened.
Important.
Do not use any power tools. Tighten the current screws manually. Do
not use additional tools or force to tighten the screws, as this can damage the
plate.
9.
Screw the top and bottom screws (
) until fully tightened.
Picture 24. Installed Device
10.
Alternatively, put the Devices power cords through the appropriate holes in a wall.
11.
Repeat steps 3-10 for each Device.
Attention.
Perform
the Device
’
s wall mounting from the top to the bottom.
12.
If you intend to use the Masterbox (for Model MS only), c
onnect the Devices one-
by-one
with Rj12 cables (supplied with each Device). Use the
appropriate sockets
at the bottom of the stator.
Picture 25. Sockets at the bottom of the stator to connect the Devices with Rj12 cables
(for Model MS only)
SOCKETS