HyperPAC™ User Manual
www.hypertech.com
11. If the data was entered correctly and you wish to use this data for the track
calibration, touch OK. If at any time in the future you wish to no longer use this time for
a track calibration , return to this review screen and uncheck the “Use this Data” box.
After touching OK, the unit will return to the “Run Setup” screen.
12. If you intend to use only one run for your calibration, touch END SESSION. But if
you are using more runs for calibration, touch NEXT RUN, then touch TRACK
CALIBRATION, and keep repeating these procedures until all runs have been entered.
When you are finished, touch END SESSION.
13. The track calibration is now automatically active and will take effect on all
subsequent runs.
14. If at any time in the future, you wish to either remove this calibration or calibrate
your HyperPAC™ to a different track, simply return to the calibration verification screen
(located where ) and un-check the Use this Data check box for each run you entered
during the calibration procedure .
15. This removes the track calibration, and you may recalibrate for a different track, if
you choose. Unless or until you do a recalibration, all of your subsequent test results
• (901) 382-8888
Page 47 of 66
