Installation
2
1.
Determine the place where the Hypertec ISDN 10T Router is to reside, it is designed to rest on a
flat level surface such as a desktop or table. Make sure that an AC power source and the ISDN
termination are nearby.
Connect the Ethernet LAN to any or all of the four RJ 45 ports labeled Ethernet using cables
with RJ45 connectors. You may daisy-chain the Hypertec ISDN 10T Router embedded repeater
to other external Ethernet hubs to accommodate more than 4 LAN users by using a cross-over
RJ45 cable (see Figure 0-2, Using Ethernet Hubs).
Figure 0-2, Using Ethernet Hubs, all Ethernet stations can access the Internet
through the Hypertec ISDN 10T Router
2.
Connect the ISDN line to the Hypertec ISDN 10T Router using the supplied RJ45 cable.
Connect one end to the ISDN line termination and the other end to the RJ45 on the Hypertec
ISDN 10T Router rear panel labeled ISDN. If your Hypertec ISDN 10T Router is equipped with
ST interface, use the same RJ45 cable to connect the Hypertec ISDN 10T Router to the NT1
device (normally provided by the telephone company).
3.
If you intend to connect analog devices such as modems, telephones or faxes to the Hypertec
ISDN 10T Router, use standard telephone RJ11 cable and connect them to the two RJ11 ports
on the Hypertec ISDN 10T Router rear panel labeled Phone1 and Phone2. These are general
purpose ports and either can be used for any analog devices, phone, modem, fax machine.
4.
If you intend to use an alphanumeric terminal as a console for managing the Hypertec ISDN
10T Router, connect its RS232 port to the DB9 port on the Hypertec ISDN 10T Router rear
panel labeled Console. Use the DB9 to DB9 straight through cable. You may need a DB9 to
DB25 adapter at the terminal end if the terminal RS232 uses a DB25 connector.
5.
Apply power to Hypertec ISDN 10T using the AC power adapter and cable supplied with the
Hypertec ISDN 10T Router. Connect the end of the cable with the small round DIN connector
to the DIN port on the rear panel of the Hypertec ISDN 10T Router labeled Power. Plug the
adapter into the AC wall outlet.
There is no ON/OFF switch on the Hypertec ISDN Router, when the adapter is plugged into the
wall outlet, the Hypertec ISDN 10T Router is automatically ON and is operational.
