HyperSID Manual - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -HyperSynth
Setting up HyperSID in your host application:
1.
Deselect your Soundcard MIDI out port in your host or any other running
application using MIDI out Port.
2.
After installing HyperSID, Open HyperSID in your host from VST instrument
list.
3.
From the HyperSID Master section select your MIDI out port which is
connected to the hardware unit.
4.
Select a preset from the preset manager.
5.
Make sure that THR bottom in the Master section is selected.
6.
Select the audio input of your soundcard from the host mixer.
7.
Play some notes and Enjoy!
Note:
If you’ve done the above steps and encountered with any errors please read the
“
T
roubleshooting “chapter
.
In-Depth Descriptions
Oscillators
OSC1, OSC2, OSC3 are the main core of the synth.
In the monophonic mode you can combine these
sources to generate more complex sounds so they
can have different settings but in the polyphonic mode
all 3 oscillators must have the same settings in order
to allow the synth to act in a 3 Voice polyphonic mode.
There is no difference among oscillators so here we’ll
just explain the first one .
OSC1 Settings consist of 3 main parts:
1-Waveform 2-Pitch 3-Amp Envelope
Waveform Settings:
4 different wave shapes can be selected including Tri , Saw, Sqr and
noise. Besides, you can select more than one waveform and the output becomes the logical
AND of the selected input waveforms (SID Chip Feature). This result in generating
unpredictable sound with unique SID accent.
There is an option to change the Sqr waveform pulse width with PWM knob (0%-100%) and
also for more precise control over this parameter you can tweak the range knob to get the
smaller range (25%-50%-100%).This feature is useful in controlling PWM parameter using
mouse, Midi Controller and modulation source.
