HyperSID Manual - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -HyperSynth
Hardware Connections:
Midi link between your sound card and Hardware unit.
Mono audio link between your sound card and Hardware unit.
Power supply connection
Audio in (mono) Midi out
Quick Start
Architecture
HyperSID is a subtractive synthesizer that has an ability to use all the SID chip hardware
features in addition to many new software based features. It acts like a control panel for the
Hardware unit so it doesn’t generate any sound. HyperSID is fully compatible with VST 2.0
hosts and tested via Nuendo, Fl Studio, Logic audio and etc.
Fig1 shows the architecture of HyperSID including both hardware and software modules.
Audio signals are represented by black lines and Modulation paths are represented by red
lines. Except the green boxes (Env1,Env2,LFO,Step LFO) which are software implemented
modules other modules are totally built in SID chip features .The Audio Signal routings are
hard-wired So you can’t change the audio signal path unlike the way has shown in the
picture .
Modulation paths are software implemented in this case you can have versatile choices. For
routing different sources to destination, you can also have multiple destinations for every
source and multiple sources for every destination.
Audio out (mono)
MIDI IN
HyperSID Hardware Unit
Power Supply
Power
Supply
