Hyperion EOS 0840i, Manual

Page: 17 / 34

15 · Hyperion EOS 0840i
BATTERY MEMORY PROFILE SETUP
[ BATT MEMORY 1 ]
ENTER SET->
BATT TYPE
LiPo
BATT VOLTS
7.4V ( 2S )
The charger can store up to 10 different charge/discharge profiles for your convenience. These stored
profiles can be quickly chosen without having to go through the entire battery program setup again.
If you choose to alter or program the battery memory profile then press START/ENTER, then change
the settings with the (-) or (+) button. You may store your programed settings by pressing ENTER.
Note: All following screenshots are for 2S LiPo example only
Enter the battery memory program.
(10 different charge/discharge profiles can be stored).
Select the battery type(LiPo/LiFe/LiIon/HvLi/NiMH/NiCd/Pb).
Select the voltage and number of cells(1S-8S).
1. Battery Memory Set
START/ENTER
DEC INC
DEC INC
Regenerative Discharge transforms the energy from the connected discharging battery pack to the
Lead Acid battery powering the charger. The regenerative discharge current can reach up to 40A Max.
It works only when the power source is a 6P or 12P Lead Acid battery.
By Factory Default setting the Regenerative Discharge function is disabled. Please follow below steps
to active it:
When the power source is 6P or 12P Lead Acid battery and the Regenerative Discharge function is
active all discharge modes will switch to regenerative discharge modes automatically.
For example,
Note1: Please make sure to set the right current and cut voltage of the Lead Acid battery and change
the setting when you change the power source every time.
If the power source is a DC power supply the Regenerative Discharge will be off automatically.
BATTERY MEMORY SET AND CALL OUT
REGENERATIVE DISCHARGE (Lead Acid PB Battery input only)
PROGRAM SELECT
SYSTEM SET->
USE Regenerative
Discharger? > Y
LiPo DISCHARGE
2.0A 7.4V (2S)
LiPo REGEN DSC
2.0A 7.4V (2S)
Note2:
If the power source is a 8P, 9P or 10P Lead Acid battery, but not 6P or 12P PB battery the
regenerative discharge function will not be enabled and will automatically turn off.
Note3:
If the Lead Acid battery is fully charged while in regenerative discharge mode, the charger will
audibly beep 5 times and then switch to default internal discharge process until it is finished
Note4: