Hyperion EOS 0840i, Manual

Page: 14 / 34

· 12 Hyperion EOS 0840i
OPERATING PROGRAM
The below mentioned flowchart show the entire programming menu. It is highly
recommended to have these flowcharts nearby while learning how to operate this
charger.
A memory profile is available for setting and storing information for up to 10
different batteries. Once a batteries information is stored it will be stored until the
user changes these settings again manually. When you select a pre-saved memory
profile the charger is automatically ready to charge.
If you do not wish to use the battery memories, this charger can be manually set
before each use.
2. Getting started
(1)
(2)
For following step, all are basing on manually set
3. BATT/PROGRAM Select
BATT/PROGRAM
LiPo BATT
4. Mode Select
6. Program Start
LiPo BALANCE CHG
2.0A 11.1V (3S)
Press INC and DEC to go through all the programs and press
START/ENTER to enter LiPo BATT Program.
5. Battery Setting
LiPo BALANCE CHG
2.0A 11.1V (3S)
Press INC and DEC to go through all the modes and press
START/ENTER to enter LiPo Balance Charge Mode.
Press START/ENTER, the current value will start to blink, press
INC and DEC to change the value and press START/ENTER to
confirm your setting.
At the same time, the battery cells number will start to blink,
press INC and DEC to change the value and press
START/ENTER to confirm your setting.
LiPo BALANCE CHG
2.0A 11.1V (3S)
BATTERY CHECK
WAIT...
LiPo BALANCE CHG
2.0A 11.1V (3S)
Press and hold START/ENTER for 3 seconds to start the
program.
The charger is detecting the battery cell.
R shows the number of cells detected by the charger and S is
the number of cells set by you at the previous screen. If both
numbers are not identical, press STOP to go back to previous
screen to recheck the number of cells of the battery pack before
going ahead.
R:3SER S:3SER
CANCEL(STOP)
START/ENTER
START/ENTER
START/ENTER
START/ENTER
START/ENTER
> 3 Seconds