Chapter 4
4-4
ICE 5000 and 5500 Hardware and Installation Operators Manual
940184-003, rev. B
4.
Insert the male connector on the 12-foot cable from the terminal transceiver into the female
connector on the single-unit adapter cable.
5.
If the 12-foot cable is not long enough, it may be extended up to 100 feet by using any six-
conductor, one-to-one standard telephone extender cable available at various electronic appliance
retail outlets. The cable may be extended up to 1000 feet by substituting a terminal transceiver
interface for the single unit adapter cable.
Extending Basic Coverage Area
If the basic system does not cover enough space or major gaps exist in the coverage, you can extend
the area covered. The example in Figure 4-2 shows how to extend coverage or fill in gaps by adding a
terminal transceiver interface and an additional terminal transceiver.
Figure 4-2. Extending basic coverage
Installing Extended Basic Coverage Area
Use this procedure for installing the extended basic coverage wireless hardware.
Step-by-Step
To install the extended basic coverate area:
1.
Ensure the host terminal is properly configured and connected for use as a standard POS
terminal.
See the manual provided with the host POS terminal.
2.
If this is a system upgrade from the basic system, discard the single unit adapter cable. Insert one
end of the PIN pad cable, Hypercom P/N 810022-001, into the PIN pad port of the host POS
terminal. Insert the other end of the PIN pad cable into the connector marked
To Terminal
on the
terminal transceiver interface.
W
ARNING
To avoid damaging the terminal transceiver unit, do not insert the cable connectors from the single unit
adapter or the terminal transceiver into any receptacle designated for use with the premises telephone
system .
