ENGINE 3-26
Crankshaft installer : 09900-32812
Conrod holder : 09910-20116
Standard
35.0
±
0.1 mm
(1.378
±
0.004 in)
Crank web to web width
●
Measure the length between the webs referring to the
figure at right when rebuilding the crankshaft.
●
When mounting the crankshaft into the crankcase, it
is necessary to pull its left end into the crankcase
with the special tool.
Never fit the crankshaft into the crankcase by driv-
ing it with a plastic hammer. Always use the special
tool, otherwise crankshaft alignment accuracy will
be affected.
CAUTION
CRANKCASE
●
Wipe the crankcase mating surfaces (both surfaces)
with cleaning solvent.
●
Apply
BOND 1215
uniformly to the mating surface
of the left half of the crankcase, and install the dowel
pins.
●
Install the two dowel pins.
●
Tighten the crankcase screws securely.
●
Check if crankshaft rotates smoothly.
BOND 1215
Summary of Contents for WOW 50
