6-11 CHASSIS
③
TOE-IN ADJUSTMENT
The procedure for adjusting the toe-in as follows.
●
Place the vehicle on level ground and set the handle-
bar straight.
Make sure that all tires are inflated to the standard
pressure.
●
Loosen the lock nuts
①
on each tie-rod.
●
Measure the distances A and B of front wheels (in
illustation) and adjust the tie-rods, right and left, to
within the specified range.
kPa
25
25
kgf/
㎠
0.25
0.25
psi
3.6
3.6
Front
Rear
COLD INFLATION TIRE PRESSURE
Inside lock nuts
①
are left-hand thread.
CAUTION
NOTE :
A - B = Toe-in
Toe - in
6 mm (0.236 in)
●
Temporarily tighten the four lock nuts.
●
Check that the distances C and D ( in illustration ) are
equal. If the distances C and D are not equal, readjust
the tie-rod, right or left, whichever makes the toe-in
value closer to the specification. Check the toe-in
again by measuring the distances A and B.
●
If the toe-in is not within specification, repeat the
adjustment as above until proper toe-in value is
obtained and at the same time the distances C and D
become equal.
●
Tighten the four nuts
①
after adjustment of toe-in is
made.
Tie-rod lock nut
: 22.4~35.7 N
ㆍ
ㆍ
m (2.24~3.57 kg
ㆍ
ㆍ
m)
90�
①
Tire side
Summary of Contents for WOW 50
