HYOSUNG GD250, Owner'S Manual

Page: 48 / 98

47
WARNING
1. Inspect every day once before riding
the motorcycle.
2. The transmission is in neutral.
3. The ignition switch is in the “ON”
position.
4. The engine stop switch is in the “ ”
position.
5. Moving the side stand to the fully
upper position.
6. Squeeze the clutch lever.
RIDING TIPS
STARTING THE ENGINE
Before attempting to
start the engine make
sure :
Running the engine indoors or in a
garage can be hazardous.
E x h a u s t g a s c o n t a i n s c a r b o n
monoxide, a gas that is colorless and
odorless and can cause death or severe
injury.
Only run the engine outdoors where
there is a fresh air.
CAUTION
Running the engine too long without
riding may cause the engine to
overheat.
Overheating can result in damage to
internal engine components and
discoloration of exhaust pipes.
Shut the engine off if you cannot begin
your ride promptly.
WARNING
The
『 』
is equipped with the
side stand ignition interlock system.
If the transmission is in neutral or the
side stand up, you can only start the
engine by squeezing in the clutch lever.
This side stand ignition interlock
system prevents the motorcycle from
being started with the side stand down.
Make sure that the side stand ignition
interlock system is working properly
before riding.
CAUTION
The position lamp, meter lamp, tail
lamp and license plate lamp on this
motorcycle always comes on when the
ignition switch is turned to the “ON”
position.
The head lamp is always lit when
starting the engine.
CAUTION
●
·
R e l e a s e t h e s t a r t e r s w i t c h
immediately after the motorcycle
has started.
● ··
Avoid pressing the starter switch
when the engine is running, or the
starting motor damage.
●
··
Do not engage the starting motor for
more than five seconds at a time as
it may overheat the wiring harness
and starting motor.
If the engine does not start after
several attempts, check the fuel
supply and ignition system.
(Refer for Page 85)